Puffco Peak Pro User Guide — Premium E-Rig

Complete Puffco Peak Pro User Guide

The Puffco Peak Pro is a premium E-Rig designed exclusively for concentrates. It features the 3D Chamber with 360-degree heating, real-time temperature control, and wireless charging — setting a new standard for smart E-Rigs.

---

Unboxing — What Is in the Box

• Puffco Peak Pro base unit (built-in battery)
• 3D Chamber (Atomizer)
• Glass Attachment
• Carb Cap
• Dabber Tool
• Wireless Charging Dock
• USB-C cable for Dock
• Cleaning cloth

---

Initial Setup

Step 1 — Install the Chamber

Remove the 3D Chamber from packaging and insert it into the top slot of the base. Twist gently until it locks into place. Do not force it.

Step 2 — Attach the Glass

Place the Glass Attachment onto the base, aligning the water hole with the groove. Press down gently until snug.

Step 3 — Fill with Water

Add clean water through the mouthpiece opening. The water level should sit just above the percolator. Do not overfill or water may enter the Chamber.

Step 4 — Power On

Double-click the front button quickly to power on. The LED ring will illuminate, indicating the device is ready.

---

4 Heat Profiles

Single-click the button to cycle through profiles. Each color represents a different temperature range.

> Tip: Start with Blue or Green and adjust upward based on your preference.

---

How to Dab

1. Select your desired heat profile.

2. Use the Dabber to load a small amount of concentrate (rice-grain size) into the 3D Chamber.

3. Double-click and hold to begin heating — the device vibrates when ready.

4. Place the Carb Cap on immediately and inhale slowly and steadily.

5. Each session lasts approximately 1 minute before auto-shutoff.

Boost Mode

During an active session, double-click to extend the heat cycle by 15 seconds. This helps vaporize any remaining concentrate.

---

Puffco Connect App

Download the Puffco Connect app (iOS / Android) and pair it via Bluetooth.

Key features:

• Fine-tune each heat profile to the exact degree
• Create unlimited Custom Heat Profiles
• View usage statistics and total dab count
• Update device firmware

---

Maintenance and Cleaning

After Every Session

• Use a Cotton Swab dipped in Isopropyl Alcohol (90%+) to wipe the inside of the 3D Chamber while still warm.
• Replace the water in the glass after each use.

Deep Clean (Weekly)

• Remove the 3D Chamber and soak in Isopropyl Alcohol for 30 minutes. Rinse with clean water and let it air dry completely.
• Clean the glass with Alcohol, then rinse thoroughly.
• Wipe down the base with a lightly dampened Alcohol cloth. Avoid getting liquid in the charging port.

Chamber Replacement

When flavor quality degrades or the Chamber develops stubborn residue that cannot be cleaned, it is time to replace the 3D Chamber.

---

Pro Tips

• Dab size: Smaller loads (rice-grain size) deliver better flavor than large loads.
• Spin the Carb Cap: Rotating while inhaling improves heat distribution and extraction.
• Wireless charging: Place the device on the Dock after every session to keep the battery topped up.
• Clean immediately: Swabbing while the Chamber is still warm makes cleanup much easier.
• Never dry burn: Do not run a session without concentrate as this will damage the Chamber.