DynaVap VonG X Guide - Using with Glass Bong & Water Pipe

DynaVap VonG X Guide - Glass-Ready Thermal Extraction

The DynaVap VonG X (Vaporizer ON Glass) is a premium model designed to work directly with water pipes and glass bongs without any additional adapters. It features a beautiful hardwood Body, a fast-heating Titanium Tip, and a rotating Airport Sleeve for effortless airflow control.

---

Unboxing - What's in the Box

• DynaVap VonG X (fully assembled)
• Titanium Tip (heats faster, cools faster than stainless steel)
• Captive Cap
• Wood Body with integrated Airport Sleeve
• Condenser with 10mm Mouthpiece (fits 10mm joints natively)
• 14mm Adapter Sleeve (for 14mm glass joints)
• Storage Tube

What Makes the VonG X Special

• Glass-Ready: Fits 10mm joints natively, 14mm with included adapter
• Titanium Tip: Heats about 30% faster than stainless steel
• Wood Body: Beautiful, comfortable to hold, stays cooler than metal
• Airport Sleeve: Rotate to adjust airflow with one hand

---

How to Use with a Water Pipe (Glass Bong)

This is the primary feature of the VonG X:

For 10mm Bongs

1. Remove the Mouthpiece from the bottom of the Condenser

2. Insert the Condenser directly into the 10mm joint of your bong

3. The device will seat firmly in the joint

For 14mm Bongs

1. Attach the 14mm Adapter Sleeve onto the Condenser end

2. Insert into the 14mm joint of your bong

3. Make sure it fits snugly and does not wobble

Using the VonG X with a Bong

1. Fill your bong with water to the appropriate level

2. Pack the Tip with medium-ground herb (loosely, about 70%)

3. Close the Cap and insert the VonG X into your bong

4. Heat with a Torch while rotating the device steadily

5. Listen for the Click then draw through the bong immediately

6. The water will filter and cool the vapor for a much smoother experience

---

Airport Sleeve - Easy Airflow Control

The VonG X features a rotating Airport Sleeve on the Wood Body:

• Rotate closed (Airport hole covered) = tight draw, concentrated dense vapor
• Partially open = balanced airflow and vapor density
• Fully open = very airy draw, diluted vapor

---

Heating Technique for the VonG X

The Titanium Tip heats faster than stainless steel, so keep this in mind:

• Heats 2-3 seconds faster than the M7 - rotate more quickly
• Be careful not to overheat as the Ti Tip responds rapidly
• Low Temp: Heat the tip of the Cap for quick clicks and maximum flavor
• High Temp: Heat near the base of the Cap for denser clouds

Recommended Approach

1. Use a single-flame torch for maximum precision

2. Keep the flame 2-3 cm away from the Cap

3. Rotate faster than you would with a stainless steel tip

4. The click will come sooner - be ready to stop

---

Cleaning & Maintenance

Metal Parts (Tip, Cap, Condenser)

• Soak in 90%+ Isopropyl Alcohol for 10-15 minutes
• Scrub with cotton swabs, rinse with hot water, dry thoroughly

Wood Body - IMPORTANT

• Never soak in water or ISO! This will damage the wood
• Use a cotton swab lightly dampened with ISO to gently wipe the inside and outside
• Apply wood conditioner oil periodically to maintain the finish

O-rings

• Remove, clean gently
• Apply Dynawax or food-grade wax before reinserting

---

Troubleshooting