DynaVap B2 / BB3 Beginner's Guide

DynaVap B2 / BB3 - The Beginner's Guide

The DynaVap B Series (B2 and BB3) is the most accessible entry point into the DynaVap world. Designed specifically for newcomers, these budget-friendly devices use the exact same Thermal Extraction principles as the premium M7 but with a simplified, streamlined design at a lower price point.

---

Unboxing - What's in the Box

• DynaVap B2 or BB3 device (fully assembled)
• Torch Lighter included in the box (B2 often comes with one)
• Storage Tube for safe carrying
• Quick start guide

How It Differs from the M7

• Simpler Body design without complex Airport grooves
• Lighter weight, straightforward construction
• Uses the same standard DynaVap Tip and Cap
• Same extraction performance as the M7

---

First-Time Setup

1. Burn-off: Heat the empty Cap 2-3 times to remove manufacturing residue

2. Fill the included Torch Lighter with quality Butane gas

3. Test lighting the Torch and adjust the flame to a small single flame

4. You are ready to go!

---

How to Use Your DynaVap B2 - Step by Step

Step 1: Pack the Chamber

1. Grind your herb to a medium consistency

2. Remove the Cap

3. Dip the Tip into your ground herb or pinch a small amount in

4. Fill loosely to about 70% - do NOT press down

5. Replace the Cap

Step 2: Heat with the Torch

1. Hold the device at a 45-degree angle

2. Light the Torch and aim the flame at the middle of the Cap (best for beginners)

3. Rotate the device continuously - roll it between your fingers

4. Listen for the CLICK! (takes about 6-12 seconds)

5. Stop heating immediately when you hear the click

Step 3: Draw Your Vapor

1. Draw from the Mouthpiece end slowly and steadily

2. Imagine sipping a thick milkshake through a straw

3. Draw for about 10-15 seconds

4. Wait for the cool-down click before heating the next round

---

Temperature Control (for B Series)

Since the B Series has a simpler design without a complex Airport, temperature is controlled primarily through your heating position:

• Tip of the Cap = Lower temperature, more flavor
• Middle of the Cap = Balanced, recommended for beginners
• Base of the Cap = Higher temperature, thicker clouds

Tips for New Users

• Start by heating the middle of the Cap
• Once comfortable, experiment with other positions
• A single-flame Torch gives you the most control vs. multi-flame

---

Cleaning & Maintenance

Clean every 3-5 sessions for the best experience:

1. Disassemble all components

2. Set O-rings aside - do NOT soak them in alcohol

3. Soak metal parts in 90%+ Isopropyl Alcohol for 10 minutes

4. Use a cotton swab or pipe cleaner to scrub inside the Condenser and Tip

5. Rinse with hot water and dry completely

6. Apply Dynawax to O-rings before reassembly

---

Beginner Troubleshooting

Common Beginner Mistakes to Avoid

1. Heating past the click - this is the number one mistake. Always stop immediately.

2. Packing too tightly - loose packing allows airflow for proper extraction.

3. Using a soft-flame lighter - you need a Torch (jet flame), not a regular lighter.

4. Drawing too hard and fast - slow, gentle draws produce the best vapor.

5. Not rotating while heating - uneven heating leads to uneven extraction.